Hi everyone, I need some advice please. I've had my S1 10w just over 4 weeks and used it about 10 times up to now just for engraving. Anyways on about the 3rd go the laser wasn't showing in the right place on Xcs in one case the module was completely off and making a clunking sound at the back right side of the machine trying to reset it's locating pin unable to find the position. I turned both machine and Xcs off and on didn't work, cleared cache which worked, all was ok for a few goes now it's started again, turning everything on and off worked a few times now it's getting worse, Laser module is not showing in the right place, Xcs says laser module is off processing area, and now when I measure a rectangle it's only showing as a line 🫣. It's driving me mad. I've turned machine off and on, closed Xcs, cleared cache. Any ideas?. I've took some videos of this mornings fun. Any advice gratefully appreciated. Thank you.