I have an issue where the area the laser can engrave does not match the processing area available in XCS.  I've attached a screenshot of the measured area using the area markup tool which shows the upper left corner of the laser's gantry zone to the lower right.  It is WAY outside of the available area in XCS, which means that anything that's placed at the bottom edge of the laser bed is considered out of the processing area, and XCS will not allow it to proceed.

XCS version is 2.3.24 and the algorithm version is 1.1.0, which are both the most up to date versions.

This is a serious problem, and has been a problem I think as long as I've had the laser.  Does anyone know how to fix this?