Hi,

I have an xTool M1 with air assist from some weeks. Air assist is mounted correctly as described in the manual but I have a problem with a tube. The tube is very rigid and I can't complete my works because when the laser move towards the back, always the tube remain between the laser body and the axis support so the movement was blocked. I tried with my hand to change the tube curve and to make the tube less rigid, but the problem remain the same. I lose a lot of wood panel and It is impossible to work with this situation. I put a photo to understand better the problem. How can I do to avoid it? Is there a new air assist cable perhaps less rigid? I'm not happy with my M1.