Account Center

UPDATE: It turns out this is a bug in 1.4.1, it is gone when going back to 1.3.6!

I updated Studio to version1.4.10 today, and ever since then I cannot cut anything on the honeycomb of my S1 40W. It keeps throwing the M53 C1 riser base exception error, and no matter how I tighten the screws etc. according to the instructions, it's not going away.

I then installed the "old" Xtool Creative Space again and there are no problems, it just cuts as intended!!!

Two questions:

Has anyone else had this problem?

Is there a way to download a previous version of Studio? I could only find a link to Creative Space but all I want it to go one version back

I hope this gets resolved soon!