Auto-snapping and Precise Vector Path Selection
Updated Dec 31,2024
Updated Dec 31,2024

To enable these functions, you can navigate to the Settings.

Auto - snapping

This function is enabled by default. When enabled, the object moved close to the edge, center point, or grid line of another object will automatically align with these reference points, and blue lines will appear at the snapping positions.

Precise vector path selection

This function is disabled by default.
When this function is disabled, you can select a vector path by clicking on the selection box of it. The selections boxes of multiple vector paths, however, may overlap, causing difficulty in selecting the target vector path.
As shown in the following figure, it is difficult to select the purple line because it is located within the selection box of another line.
When this function is enabled, no selection box is provided for vector paths. You need to move the mouse pointer close to a line to select it. In this way, you can select a vector path without selection box interfering.
As shown in the following figure, you can select a line by moving the mouse pointer close to it and then clicking.
Preview
Was this page helpful?
1 out of 1 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Copyright © 2024 xTool All Rights Reserved.
Call Us
Telephone
Pre-sales : +1(970)638-7030
After-sales : +1(775)587-7760
Email
Pre-sales : vicky@info.xtool.com
After-sales : support@info.xtool.com
Service Time
Mon-Fri : 7:00 am - 5:30 pm (PT)
Sat-Sun : 8:30 am - 5:30 pm (PT)
Copyright © 2024 xTool All Rights Reserved.