Introduction

Given the fixed focusing range of M1, once exceeding this range, "automatic measure" and "laser focus" will be disabled, potentially leading to processing problems.

Hence, it is paramount, during processing, to position the material surface within the range.

With the surface of the bottom plate at the time of factory shipment as the reference surface 0 mm, the relationship between the focusing range and the XCS automatic measurement range is as follows:

How to Do It

#1 When using the riser base with the honeycomb panel, select either the Open Plane or the Laser Cylindrical for processing.

#2 Refer to the table below for placing the honeycomb panel at the correct height based on the dimensions of the processing material.

#3 If the material size for processing is not included in the table, adjust the material height to ensure the processing surface is within the focusing range while making sure M1 is placed steadily during processing.

Note

As the provided data represents theoretical values, slight variations may occur from actual parameters due to factors including unavoidable assembly tolerances, measurement errors, and flatness discrepancies.

Help Us Improve

If this article or video doesn't effectively assist you in resolving the issue, please let us know by clicking the “No” button in the “Was this page helpful?” section below, and leave your feedback in the pop-up suggestion box. Our knowledge base team will review it and consider it for future updates.

Still Need Help?

If you need any human assistance, please create a ticket by clicking the “Submit a Ticket” in the “Help Ticket” section below. Our service team will get back to you in 1 business day via E-mail.