Welcome to xTool Community Support
xTool F1 Series
Engraving picture
luka182x
Published on Mar 31,2025
21
86

Hi I'm new to xTool and just bought the F1 Light.I made a mistake  a little mistake  I thought I was getting the regular xTool F1, and didn’t realize the F1 Light doesn’t have the IR laser. What I need help with is this:
I have a photo of my dog that I’ve been trying to engrave, but the quality always turns out bad whether it’s on wood, paper, or anything else. And it’s not just that photo every image I upload comes out low quality.Could someone please help me i will upload my dog's picture,can somebody Prepare it properly for engraving with the diode laser and give me the exact settings I should use (power, speed, DPI, etc.)?Any help would mean a lot thank you! 

i will upload orginal picture and picture and setttings i try to make second picture 

Preview
Attach Files
  • majlo2hd.png
  • majlo3.jpg
  • e1.jpg
  • e2.jpg
  • Software
    Project
    Other
    Copyright © 2024 xTool All Rights Reserved.
    Call Us
    Telephone
    Pre-sales : +1(970)638-7030
    After-sales : +1(775)587-7760
    Email
    Pre-sales : vicky@info.xtool.com
    After-sales : support@info.xtool.com
    Service Time
    Mon-Fri : 7:00 am - 5:30 pm (PT)
    Sat-Sun : 8:30 am - 5:30 pm (PT)
    Copyright © 2024 xTool All Rights Reserved.