Hi everyone!

I recently get a P2 device, tried some jobs and get some questions.

What kind of lens are included by default? (2",1,5", etc), does it exist any different lens?

Does anyone knows how to measure manually the focus distance? only automatically proccess available?

There is any possibility to defocus manually on the engraving proccess?

There is any possibility to engrave (raster mode) from the bottom to the top?  i would need this proccess for some materials.

I felt on cutting proccess (thin materials) on the edge of the vectors (when motors are decreasing speed) it burns too much, is there any parameter i can play to this “correction” parameter?

I test to decrease air flow of air assist, i see the minimum is 30%, can i desactivate it? or go to 0%?

can i addapt an external compressor to the air assist?

and finnally, there is any way to moxe the axis manually?

Thank you in advance.