I have the D1 Pro extended, running XCS v2.0 Beta. I have a project in XCS 2.0 placed on the grid at coordinates 100 x 100. When I proceed to engrave, the laser starts engraving at coordinates 0 x 0. How can I correct this issue?  I also cannot find where to switch between laser spot and crosshairs. Will the laser move to the correct position or do I have to manually move it to the starting point?

I sent xTool an email, this is what was returned from the AI.  “it's important to ensure that the design file and the machine's coordinate settings are aligned. You may need to recalibrate the machine and check the design file for accuracy.  Regarding the option to switch between laser spot and crosshairs, the functionality may vary depending on the specific software version and machine model.“. I told them the machine and software I am using.  I need specific information on how to recalibrate the machine and check the file.  I also need information on how to switch between laser spot and crosshairs using CXS v2.0 Beta.  
I would greatly appreciate any assistance anyone can provide.

Thanks