I emailed support, but I thought I would throw it out to here as well. I'm a new laser owner and after assembling my new D1 Pro, I noticed the tip of the laser module was sitting flush with my table top. Upon further inspection, there is nothing to hold the tip up inside the laser module that I can see. It is fairly loose, and when adjusting the height of the laser module, it slips down, and even fell right out. I don't know if I have all the terminology right, like I said I'm a total noob. I attached a pic to illustrate what's falling out. I don't understand it, and I feel like this piece being loose will greatly impact performance. Just curious if anyone has seen anything similar, or has any ideas.