Note:

• Handle the honeycomb panel with care. Dropping or crashing the honeycomb panel may deform it and thus cause distance measurement failure and poor processing results.
• Do not place heavy objects on the honeycomb panel. Heavy load may deform it and thus cause distance measurement failure and poor processing results.
• The honeycomb panel has a flatness tolerance of ±0.5 mm due to production limitations, which means that some areas may protrude or sink by 0.5 mm or less. This does not affect the function of the honeycomb panel.
• Residues may remain in the honeycomb panel after material processing. You are advised to take it out and clean it every time after a material is processed.

List of items

Use the honeycomb panel

Thickness of materials supported

0 ＜ h ≤ 25

Place the honeycomb panel

1. Remove all the slats from xTool P2.

2. Place the honeycomb panel into the machine, resting its left side on the slat holders first and then the right side with your hand holding the handle.

Note: Ensure that the handle faces upward and is on the right side of the machine.

3. Lay down the handle of the honeycomb panel, making it parallel to the surface of the honeycomb panel.

Use the material pins

Place the material on the honeycomb panel. Then, use four material pins to secure the four corners of the material.

Note: After inserting a material pin, lay down its ring pull. Otherwise, the ring pull may get in the way of the movement of the laser module.

To remove a material pin, lift it with its ring pull.

Start processing

1. Connect xTool P2 to XCS.
2. Design or import images or other elements for processing.
3. Set the processing mode and complete auto-measure.

Note: Use the auto-measure instead of manual-measure to measure the thickness or distance of a material.

4. Set the object processing parameters. For details, see "Use xTool Creative Space (XCS) to Operate xTool P2."
5. Click Process to preview the object.
6. Click Start and press the button on xTool P2 to start the processing.
7. Wait for the processing to complete.

Maintenance

 You can use the brush delivered with the honeycomb panel to clean the cells of the honeycomb panel.